Install Instructions

ManualsBrandsBarber Colman ManualsActuator AccessoriesStatic Pressure Probe

All brand names, trademarks and registered

trademarks are the property of their respective

owners. Information contained within this

document is subject to change without notice.

F-24002-2

www.tac.com

TAC

1354 Clifford Avenue

P.O. Box 2940

Loves Park, IL 61132-2940

PRE-INSTALLATION

Inspection

Visually inspect the carton for damage. If damaged, notify the

appropriate carrier immediately. Visually inspect the device

for obvious damage due to shipping. Return damaged parts.

Required Installation Items

• Tools (not provided)

Flat blade screwdriver

Small open ended wrench

• Two (2) #10 sheet metal screws (provided)

• One (1) grommet (provided)

INSTALLATION

See Figure 1. AP-302 Installation.

Caution:

• Installer must be a qualified, experienced technician.

• Do not locate the device in areas subjected to excessive

vibration or corrosive atmospheres.

1. Cut 5/16" (8 mm) hole in duct.

2. Place grommet over end of probe and slide up probe

until tight against mounting flange.

3. Insert probe and rotate probe until arrow is in direction of

air flow.

4. Mount flange to duct with two (2) #10 sheet metal

screws.

Air Connection Options

1/4" Copper Tubing

1. Install compression fitting to probe air connection.

2. Remove compression nut and copper ferrule from probe

air connection and slide them onto copper tube.

3. Align copper tube to compression fitting and secure.

1/4" Plastic Tubing

1. Install compression fitting to probe.

2. Remove compression nut and copper ferrule from probe

air connection.

3. Slide compression nut onto plastic tube.

4. Discard copper ferrule and slide plastic ferrule onto

plastic tubing.

5. Install tubing insert into end of plastic tubing.

6. Align plastic tubing to compression fitting and secure.

AP-302

Static Pressure Probe

Installation Instructions

Figure-1 AP-302 Installation.