Operating Instructions and Installation Instructions

44 www.barbecook.com
solVInG problems
Problem Probable cause Solution
Impossibletolightburner(withigniter
ormatch)
•Blockedventuritubes •Cleanventuritubes
Notenoughheat •Gascylindervalveisnotopen
•Venturitubesnotpositionedoverexhaustvalves
•Blockedburneropenings
•Cylinderisemptyoralmostempty
•Regulatornotfittedcorrectlyoncylinder
•Opengascylindervalve
•Reinstallventuritubes
•Cleanopeningsorfitnewburner
•Newcylinder
•Tightenupconnectorofregulator
•Disconnecthose
Yellow flames •Venturitubesarepartlyblocked
•Saltonburner
•TheproductisconnectedtoButhane.
•Cleanventuritubes
•Cleanburner
•ConnecttheproducttoPropanewiththerightconnector.
Flamesjumpingoutoftheburnerbox •Windyweather
•Cylinderalmostempty
•Thebottomoftheburnerbowlisdirty.
•Movebarbecuewithrearsidepointingtowardsthewind
•Newcylinderorfillup
•Cleanthefirebowlofthebarbecue.
Excessiveheatandflare-ups •Toofattyfood
•Blockedfatdrainhole
•Cookingsystemnotpositionedcorreclty
•Trimexcessfatorreduceheat
•Cleanbottomofburnerboxandburner
•Positioncookingsystemcorrectly
Flamesbehindcontrolpanel •Blockedventuritubes •Shutoffgasimmediately,allowbarbecuetocooldownand
cleanventuritubes
Regulatorhumming •Temporarysituationcausedbyhighoutsidetemperatureor
fullcylinder
•Thisisnotadefectorahazard
Incomplete flame •Blocked,piercedorrustedburner •Clean/replaceburner
TroUblesHooTInG GUIDe For eleCTrIC IGnITIon
Problem Probable cause Solution
Nosparkswhenpressingtheignition;
no sound
•Batterynotinstalledcorrectly
•Emptyormissingbattery
•Ignitionbuttonnotinstalledcorrectly
•Defectivesparkgenerator
•Installbattery(ensurethat“+”and“-”areorientedcor-
rectly,with“+”atthetopand“-”atthebottom)
•ReplacewithnewAAbattery
•Screwoffbuttonandreinstall
•Replacesparkgenerator
Nosparkswhenpressingtheignition;
sound is present
•Faultyground
•Burnerandelectrodearepositionedtoofarapart
•Removeandreconnectallconnectionswithsparkgenerator
and electrodes
•Bringtheelectrodeclosertotheburnerbybendingitslightly
Sparksarepresentbutnotwithallelec-
trodesand/ornotpowerfulenough
•Faultyground
•Sparkflashoverawayfromburner(s)
•Lowbattery
•Electrodesarewet
•Electrodescrackedorbrokenn“sparksarepresent”
•Removeandreconnectallconnectionstothesparkgenera-
torandtheelectrodes
•Ifsparksarepresentthatdonotoriginatefromthe
burner(s),thewiringmaybedamaged.Replacethewiring.
•ReplacewithnewAAbattery
•Usepapertissuestoremovethedirt
•Replacecrackedordefectiveelectrodes
Man_CEBU_2.1_130110_A.indd 44 10/01/13 15:09