User Manual

Table Of Contents

4.1.4 Start the appliance

Warning:

• Keep a minimum distance of 100 cm of the appliance when you start the

pilot light.

• When the pilot light goes out, always wait 5 minutes before you start it

again.

Note:

• The main burner burns at maximal height after start-up.

• If the pilot light goes out and you start the appliance too early, the remote

control will start but the fire will not burn. Restart the remote control.

• Start the appliance with the on/off button(s). Refer to

4.3

4.2 Set the remote control settings

4.2.1 Set the one/two-button operation

• When the display shows '1', the one-button operation mode is selected.

• When the display shows '2', the two-button operation mode is selected. This mode will

prevent accidental start-up of the appliance.

1. Remove the batteries from the remote control.

2. Put the batteries in the remote control. The screen starts

to blink.

3. Push and hold the on/off button for approximately 10

seconds. The current setting of the remote starts to blink

4. When the number changes and stops to blink, release

the button.

• The '1' changes into '2' when the remote control is

set to the two-button operation.

• The '2' changes into '1' when the remote control is

set to the one-button operation.

4.2.2 Set the temperature scale

•

If you set the temperature scale to °C, the display shows a 24-hour clock.

• If you set the temperature scale to °F, the display shows a 12-hour clock.

• Push the on/off button and the countdown timer button at the same time to change

the temperature scale between °C and °F.

OFF

1 2

Operation

14 Gas Fire Panorama 70-70