Instruction manual

You no longer
need to remove
the Baracuda
®
Auto weir valve
from the weir.
Simply depress the red pivoted
arm (A),until it locks
open the flow door.
To r ecommence pool cleaner
operation,release the pivoted
arm (A) by pressing down
on the flow door (B).
It’s that simple!
TURNING YOUR BARACUDA®
GENIUS OFF IS MADE EASY
WITH THE
AUTO
WEIR
VALVE.
A
B
1. LOW
SETTING
2. MEDIUM
SETTING
3. HIGH
SETTING
4
SECTION 2 – CORRECT SETTINGS
ADJUSTMENT SUGGESTIONS
AUTO WEIR VALVE
PROBLEM SOLUTION
The Baracuda
®
Genius
®
3000 pool
cleaner is performing too fast and/or
climbing above the level of the water.
Reduce Auto Weir Valve to medium or
low setting
The Baracuda
®
Genius
®
3000 pool
cleaner is performing slowly and/or is
not climbing the pool walls.
Increase Auto Weir Valve to medium
or high setting
The Baracuda
®
Auto Weir Valve is preset at the factory to obtain
maximum pool cleaning efficiency.Your Baracuda
®
Genius is preset on
setting 3. However,if you do experience difficulties,it can be manually adjusted
to one of the three settings (high,medium or low).You will only need to adjust
the Auto Weir Valve if the following occurs:
2
1
13
2
3
21
This end
plugs into weir
Hose attaches
to this end
Water flow