User guide

BaracodaManager v3.20 User guide June 2005

7. Repeat steps 3 to 6 above, to use other barcode readers.

8. When you end the first session of the Baracoda Manager, click on Exit to save the barcode reader(s) Bluetooth

Device Address(s) for future sessions. The Baracoda Manager can reconnect to the barcode reader(s) during future

sessions, even if you end sessions of the Baracoda Manager by switching off the computer instead of clicking on the

Exit button.

9. When you start the Baracoda Manager again (either manually or automatically at system start-up time):

>>The Baracoda Manager tries to reconnect the barcode reader(s) which were previously configured

(paired) and for which the Auto Connect mode is set (box is checked at left of the barcode reader's

identity information in the “My Paired Devices” list).

The Baracoda Manager searches for all discoverable barcode reader(s) not previously configured (which

are in the Bluetooth radio range and are in listening mode).

10. Repeat steps 3 to 6, to add any newly discovered barcode reader(s) to “My Paired Devices”.

Notes:

>>- If you switch off a barcode reader (with the reset switch or through time-out) and switch it on again, the Baracoda

Manager reconnects to the barcode reader, which returns to functional operation within a few seconds.

- If “Real time” mode and “Barcode Buffering” are enabled (see FUNCTIONS section: Setting parameters), When you

move the barcode reader out of range (more than 15 meters from the computer) and the connection is lost, the

barcode reader will store any scanned barcode(s). When you move it back within range, the Baracoda Manager

reconnects automatically and you can then upload the stored barcodes.