User guide

BaracodaManager v3.20 User guide June 2005
Product Access further product settings (see below)
Bluetooth Access further connection settings (see below)
Cancel Close window with no change
Save Record and send the new parameters to the barcode reader.
Default Settings Restore factory settings of the reader. (refer to user guide for details)
Upgrade Upgrade the BaracodaPencil with the latest version of the firmware. See chapter 12 for
more information about the upgrade procedure.
Product
Find details about product settings in your barcode reader User Manual.
Check the box to
activate Baracoda
Header
Check the box to
activate
TimeStamp fields
When Prefix/Suffix box is checked,
select Data Format (ASCII or Hex)
and type values in active fields.
When Timestamp box is checked, select
the current time both manually or asking
the Baracodamanger to synchronise with
the internal clock of the computer
Check the box to
activate Baracoda “No
Data loss mode”
Check the box to Invert
standard LED position. If
checked the Bluetooth
connection led will be on
the right and the Status
mode led will be on the left
Configure the number of barcode (0 or MAX) that
are buffered by the reader (real time mode, no
data losss mode ON, reading barcodes while
connection is off)
If the option “0” is selected the BRRs will have the
following behavior:
Once the BRR disconnected, the user will not be
able to switch the beam on and therefore will not
be able to read an
y
barcodes.
Check the box to
activate prefix &
/or suffix fields.
Check the box to
activate the
buzzer every time
a barcode is
successfully read
Check the box to
activate activate the
beep
acknowledgement by
the Host device
Configure the
volume of buzzer
(high and low
option options
available)
Select Reading
Mode.
© Baracoda, 2005 page 23 /33