User guide

Baracoda ScanWear – User Guide
September 07 5
1.
Craddle and L anyar d
1.1.
Craddle
You can install the cradle on:
- a desk, you need to stick non-skid pad under cradle.
- a 1U steel bar, Hang on directly
1.2.
Lanyard
You can only use Scanwear with lanyard. See
picture for correct installation.
2.
Battery
Recharge the internal battery by using the included AC adapter. The Adapter rating is 5V, 500mA.
When the scanner is charging, the LED is red (solid).
When the scanner is fully charged, the LED is green (solid).
A full recharge (from completely drained batteries) takes approximately 3 hours.
When the original batteries wear out, please contact your Baracoda reseller for replacements.
3.
Switchin g on the reader
Remember to fully charge the battery before first use.
In order to switch on the scanner, please press the trigger.
The scanner will switch off alone after some period of inactivity (in its standard mode Scanner will switch
off after 20 minutes of inactivity. This value can be modified by the user).