User guide

Baracoda ScanWear – User Guide
September 07 12
7.5.
Data format
The data format is the following :
Header
General_Prefix Symbology_Prefix Barcode Symbology_Prefix General_Suffix
7.5.1 .
Bar aco da H e ade r
It is a proprietary data encapsulation. It is necessary to activate the Baracoda header in 2 cases:
• to use the Baracoda keyboard emulation (Kemul) and Terminal
• to use the “No data loss” mode.
You can configure Baracoda Header through BaracodaManager.
The Baracoda header is enabled in default settings
7.5.2 .
Gen era l Pre fix / Su ffix
You can add a general prefix and/or a suffix to every barcode sent to the host device.
You can configure prefix/suffix through BaracodaManager.
There is no prefix/suffix in default settings
7.5.3 .
Sym bo logy Pre fix / Su ffix
You can add a prefix and/or a suffix to specific symbology barcode sent to the host device.
Meaning a certain prefix/suffix will be added while reading a specific symbology.
You can configure prefix/suffix through BaracodaManager.
There is no “symbology prefix/suffix” in default settings
7.6.
Beep s an d LEDs
You can enable/disable Beeps / LED Lightening using both BaracodaManager.
7.7.
Power managem ent
Mutliple parameters exist for optimisation of battery such as “Sniff period”, “Shutdown timer”, etc…
Scanner works at 20 dBm.
7.8.
Low battery
When the red LED is blinking, these indicate that the battery level is low. Recharge battery immediately.