Specification Sheet

BAR’S LEAKS TECHNICAL BULLETIN
Tech Bulletin #: TB-1150-3 Page 1 of 1
Date 1
st
Issued: May 21, 2012 Date Revised: October 13, 2014
ISO 9001 CERTIFIED
Bar’s Leaks Cooling System Repair Part #: 1150
Bar’s Products, 10386 N. Holly Rd., Holly MI 48442 USA
E-mail: [e-mail] Web: www.barsleaks.com Phone: [phone]
DANGER: Opening the cooling system while the
engine is hot or running may cause severe burns.
NOTE: Cooling systems that are dirty or partially
clogged should be flushed before usage.
Protect from freezing.
INSTRUCTIONS:
Install only in a cold engine. Shake well. Pour entire
contents of the 2-chamber bottle directly into the
radiator. If direct access to radiator is not available,
install in reservoir / overflow tank. Fill radiator overflow
tank to proper level and reinstall cap. Drive/idle engine
for 15 minutes. If leak continues, second application
may be required or mechanical attention is needed.
Leave Cooling System Repair in cooling system for
continued protection.
Bar’s Leaks
®
Cooling System Repair has twice the performance of other products
by not only stopping cooling system leaks, but adding future protection. It is
scientifically formulated to stop coolant leaks, thereby reducing antifreeze loss,
while correcting other cooling system problems helping to prevent costly repairs
and breakdowns. In addition, Cooling System Repair contains Xtreme Cool
™
which stops overheating and reduces water temperature. Works on all 4, 6, 8,
and 10 cylinder vehicles and in any gasoline, turbocharged and diesel engines. .
Use with ALL 50-50 mix types and colors of antifreeze coolant and / or water. For
most vehicles leaks stop instantly. For many vehicles, this is your last change
before paying an expensive repair bill or replacing the vehicle.
Formula B
Add Protection with:
 Water Pump Lube
 Corrosion Inhibitors
 Heat Transfer Agent
COOLING SYSTEM REPAIR
DOSAGE:
Use one bottle for regular size cooling
systems. For small cooling systems under
1.5 gallons, use half of each side of bottle.
For larger systems use one bottle for every
4 gallons of cooling system capacity.
XTREME COOL
™
Xtreme Cool™ reduces the surface tension of coolant increasing the
wetting ability. This improves heat transfer reducing coolant
temperature helping to prevent overheating and leaks.

Twice the Performance
Formula A
Stops & Prevents Leaks with:
 Carbon Fiber Sealer
 Leak Sealing Liquid
 Stop leak Treatment
Part Number: 1150
UPC Item: 0 46087 01150 8
UPC Case: 1 00 46087 01150 5
Bottle Size: 16.9 FL OZ (500 mL)
Bottle Dimensions: 3.6 x 1.8 x 8.4
Bottle Cube: 54
Case Pack: 4 bottles per case
Case Size: 7.3 x 3.9 x 8.9
Case Cube: 253
Case Weight: 5 pounds
Pallet: TI 60 HI 5 Total 300
Pallet Height: 50 inches