Specification Sheet

BAR’S LEAKS TECHNICAL BULLETIN
Tech Bulletin #: TB-1111-3 Page 1 of 2
Date 1
st
Issued: December 18, 2007 Date Revised: September 29, 2014
ISO 9001 CERTIFIED
Bar’s Leaks Head Gasket Fix Part #: 1111
Bar’s Products, 10386 N. Holly Rd., Holly MI 48442 USA
E-mail: [e-mail] Web: www.barsleaks.com Phone: [phone]
Bar's Leaks Block Seal Head Gasket Fix product is the easiest solution to
stop head gasket coolant leaks. No draining of the cooling system is
required. This formulation contains a combination of antifreeze compatible
sodium silicate sealing liquid and various size gasket sealing particles
which penetrate gaps & cracks and harden to permanently stop leaks. This
seals because of the extreme heat inside the combustion chamber
(5000°F) that works as a catalyst to permanently harden the material to
make it stronger than the actual head gasket itself. Your vehicle is a good
candidate for this product if it can idle for 20 minutes without overheating or
having to add coolant. Use on ALL water cooled gasoline and diesel
engines. Heavy duty formula works on aluminum and cast iron heads &
blocks, along with sealing all other engine cooling system leaks better than
a traditional stop leak. This includes repairing head gaskets, cylinder
heads, intake gaskets, cracked blocks and freeze plugs. Use with ALL
types of 50-50 mix antifreeze including conventional yellow, orange, pink,
red, blue and green silicate based & non-silicate based (OAT/HOAT)
coolant, and/or water. Bar’s Leaks, America’s most trusted stop leak brand
since 1947.
NOTE: Cooling systems that are dirty or partially
clogged should be flushed before usage.
Protect bottle from freezing.
INSTRUCTIONS:
1. Allow engine to cool. Make sure engine is cool
enough so radiator cap can be safely removed.
2. Shake well. Pour HEAD GASKET FIX directly
into radiator. If using in a small cooling system
under 1.5 gallon capacity, such as 4 cylinders
with no air conditioning, install ½ bottle.
Tip: If direct access to radiator is not available
and if overflow tank is pressurized, you can
install in tank.
3. Fill radiator and overflow tank to proper level
and reinstall radiator cap. Start engine.
4. Turn heater on hot and fan on high.
5. Idle engine for 15 minutes.
6. Allow engine to cool so cap can be safely
removed.
7. Top off / add coolant to radiator and leave
Bar’s Leaks HEAD GASKET FIX in cooling
system for continued protection. Drive vehicle as
normal.
Part Number: 1111
UPC Item: 0 46087 01111 9
UPC Case: 1 00 46087 01111 6
Bottle Size: NET WT 24 OZ (680 g)
Bottle Dimensions: 2.6 x 2.6 x 9.4
Bottle Cube: 64
Case Pack: 4 bottles per case
Case Size: 5.6 x 5.6 x 9.9
Case Cube: 310
Case Weight: 7 pounds
Pallet: TI 56 HI 4 Total 224
Pallet Height: 45 inches
BLOCK SEAL HEAD GASKET FIX
DOSAGE:
One (24 oz) bottle treats cooling systems from
6 quarts (1.5 gallons) to 16 quarts (4.0
gallons).
Use ½ bottle for smaller cooling systems from
4 quarts (1.0 gallon) to 5.9 quarts (1.49
gallons). For larger systems use 1 bottle for
ever
y
4
g
allons.