User Manual

WARNING: Place unit in sink and fill with warm water to the top of the lowest
brushes or the water line label. Water must be comfortable to touch. Add a
quality liquid "low suds" detergent such as Bar Maid
®
LoSUDS
®
. Granular
(powder) detergents are not recommended as they can be abrasive and cause
premature wear to gears and bearings.
WARNING: Plug machine into a grounded, G.F.C.I. (ground-fault circuit
interrupter) equipped outlet. Test and reset. Turn machine on.
IMPORTANT NOTE: SS Model Submersible machines will heat water but are
equipped with a thermal cut-off to protect from over-heating. Excessively hot
water may cause the machine to shut off. If this occurs, drain sink and refill with
only room temperature water. Wait 20 minutes for machine to cool down, test
and reset the G.F.C.I. at the end of the power cord and then restart. If machine
fails to start, test circuit breakers and/or receptacle.
For best results, wash one glass at a time. '12- start the Glass Washer
before placing glass over the brush. The center brush scrubs the inside of the
glass while the four outside brushes wash the outside. If taller glasses are
washed, a longer center brush can be used, (see Brushes). Rinse in fresh water
in second sink, then in third sink sanitize the glass. Let drain.
OPERATING INSTRUCTIONS - ALL MODELS
A few simple procedures will help ensure a long, trouble-free life:
When closing for the day, drain sink and wipe off machine.
LET WASHER DRY overnight.
Once per month, carefully lift off rubber band that protects gear housing.
Immerse machine in enough water to cover brushes and add a half cup of
vinegar or bleach. Run machine for ten minutes, rinse thoroughly and replace
band. Check overall condition. If any parts appear cracked or damaged, please
call 1-800-526-5278 or 954-960-1468. Troubleshooting advice can also be
found online at www.glasswasherparts.com.
1
2
3
CARE AND MAINTENANCE
DO NOT operate machine out of water. DO NOT use any machine if the power
cord or motor housing is cracked or damaged.
CAUTION: Ensure brushes are securely in place before turning machine on.
CAUTION: Use machine only for the purpose it was intended.
WARNING: Disconnect from the power source before servicing.
WARNING: Do not use if any parts are cracked, broken or leaking oil.
CAUTION: Do not attempt to open or service the Submersible (SS) motor. No
user serviceable parts. Call Bar Maid Customer Service at 1-866-531-6243 for
service assistance.
CAUTION: Use only genuine Bar Maid
®
replacement parts.
CAUTION: Keep machines upright!! Lying on side may cause damage.