Operation Manual
2
1.2 Before the transmitter is installed, the rim around
the hole must be cleaned with a cloth.
1.3 Remove the Self-lock Screw
①
, insert the valve stem
through the rim hole from inside.
1.4 Place the Self-lock Screw
①
on the valve stem, and
tighten with 5 Nm (44 inch pounds) torque.
1.5 Lock the rim on the tyre changer. (If the mounting
head of the tyre changer is positioned at 12 o’clock,
then the valve should be at the 7 o’clock position.)
Apply lubricant on both the tyre bead and rim. Mount
the lower tyre bead on the rim. Ensure that the tyre
bead does not touch the electronic module during
mounting.
1.6 Mount the upper tyre bead the same way. (If the
mounting head of the tyre changer is positioned at 12
o’clock, then the valve should be at the 5 o’clock
position.) Inflate the tyre to nominal pressure.
1.7 Apply soapsuds on the valve tip. If no leakage is
Inside the ty re
Outside the ty re