Specifications

27
(b) Loosen the circle wheel and remove the cap.
(c) Loosen the nut and take the filter element out.
(d) Clean or replace the filter element.
(e) After reassembly of filter, start the engine to feed gasoline into filter bowl and
check for leaks.
▲ Diesel engine
(a) Once every 600 hours operation, it is required to replace the filter assembly.
(b) Apply several drops of fuel to the around of the new filter’s seal before
installation, it should be screwed 2/3 circles again when the filter’s seal touches the
body of engine.
(c) When the warning lamp is on, drain all the water by loosing the draining
switch.
Note: Turn off the draining switch after draining water.
(2) The cleaning of fuel tank
Once every 600 hours operation, the fuel tank should be cleaned. As for the
gasoline forklift truck, it is required to take care of fire when cleaning.
1.5 Precautions of cooling system
(1) During using the forklift truck, if the temperature of the radiator or coolant is
too high, don’t open the cap of the radiator immediately. To find the reason for boiling,
use extreme care when removing the cap, the sudden release of pressure can cause
a steam flash which would cause a serious personal injury. Lower the running speed
of the engine to moderate speed, after the cooling system cooled then turn to idle
speed, loosen cap slowly to allow steam to escape, the cap can be removed. After
that, make sure the cap is tightened securely.
(2) Check the radiator coolant reservoir fluid level. It should between FULL and
LOW mark. Add the same type coolant to specified level if necessary. The coolant
can be used all the year round.
(3) Put the coolant on a safe place and mark “Dangerous Matter” for its toxicity. If
swallowed by accident, take the emergency first aid and consult a physician
immediately.
(4) According to variety working condition, periodic wiping away the dirt adhering
to the surface of the radiator with detergent, compressed air or high pressure water
(pressure less than 4kg/cm
2
) is necessary.