User's Manual

The radio consumes energy when it is power-on, and the charger cannot detect the correct battery voltage
when the battery has been fully charged. So the charger will charge the battery in constant voltage mode and
fail to indicate correctly when the battery has been fully charged.
2.5 LED Indicator
STATUS
LED
No Battery
Green and red alternately flashing
Charge Normally
Red
Fully Charged
Green
Trouble
Red blinks fast for a long time
NOTE：Trouble means battery too warm, battery short-circuited or charger short-circuited.
2.6 How to Store the Battery
a. If the battery needs to be stored, keep it in status of 80% discharged.
b. It should be kept in low temperature and dry environment.
c. Keep it away from hot places and direct sunlight.
» Do not short circuit the battery terminals.
» Never attempt to remove the casing from the battery pack.
» Never store the battery in unsafe surroundings, as a short may cause an explosion.
» Do not put the battery in a hot environment or throw it into a fire, as it may cause an explosion.
3. INSTALLATION OF ACCESSORIES
Before the radio is ready for use we need to attach the battery pack, as well as charge the battery.
3.1 Installing the belt clip
a. Install the fixing head: Install the random belt clip fixing head in the slot on the back of the two-way radio and
tighten the screws.
b. Insert the rotating belt clip: Slide the fixed head of the machine along the guide of the rotating back clip until
you hear a "click" sound.
c. Remove the belt clip: Use the key to press the disassembly engine upwards until it releases, and then push the
belt clip with your thumb until the belt clip is removed.
3.2 Installing the battery pack