Use and Care Manual

90330 Banzai 3
safety area
10 ft (305 cm)
10 ft (305 cm)
Bring the beach to your backyard with the Surf Rider Water Park™! Make your way up the climbing
wall and take a deep breath as you race down through the wave tunnel before landing with a splash!
All this fun inflates in under 2 minutes for endless summer fun!
PLACEMENTS: Use on flat lawn only, not pavement or other hard surfaces. Lawn should be free of
rocks, bumps, depressions, sticks, etc. The product should be set up in a location that has a
minimum distance of 10 ft (305 cm) from any freestanding structures or obstructions, including
houses, garages, fences, trees, playground equipment and large rocks.
INTRODUCTION
SETUP INSTRUCTIONS
Fig. A2
1. Unfold the constant air inflatable and place in the desired position on a smooth and level surface.
2. Lay out the water hose assembly and match the number on each sprayer to the correct position on
the arch of the inflatable. Once the numbers are matched, attach the sprayers to the arch and
corresponding position using the Velcro straps provided. Secure the water tubing using the Velcro
hooks & loops located on top of the arch, and along the side of the inflatable. (Fig A1-A3)
3. Attach the long intake
tube at the back of the
inflatable to the mouth
of the blower motor
using the attached
Velcro Strap. To ensure
a secure fit, wrap the
strap around the
mouth of the blower
and tightly attach the
self-sticking strap. (Fig
A4-A6)
4. Use the drawstrings to tie shut the short air release tube along the back of the constant air
inflatable.(Fig A7)
5. Position the blower in a straight line perpendicular and level to the back of the inflatable. The blower
should be placed on a stable surface and remain upright after the inflatable is inflated. The blower is
a high volume fan capable of moving a lot of air very quickly. Place the blower in an area where it will
not suck in dirt or leaves. Keep blower away from children, water and moving vehicles. Set up the
inflatable far away from any structures or obstructions. Once positioned, secure the blower with the
blower ground stakes provided. (Fig A8)
6. Do not set up over concrete, asphalt, packed earth, or any other hard surfaces. A fall onto a hard
surface can result in serious injury.
7. Locate the loops around the bottom of the inflatable and anchor them to the turf, sand soil or rock soil
with the water slide ground stakes provided. (Fig A9)
8. Ground stakes must be completely inserted into the ground so that no part of the stake is protruding
above the ground surface. This will help prevent tripping or injuries resulting from a fall.
9. Plug the blower into a properly grounded outlet and turn it on. The inflatable should inflate in under 2
minutes. Do not allow children to use the inflatable until it is fully inflated.
10. Close the water valve at the bottom of the pool. (Fig A10)
11. Fill the pool with at least 8 in (20 cm) of water before playing. Thoroughly wet all slide surfaces,
platforms and climbing walls before use to ensure optimal play performance.
12. Do not fill the product tub to more than the maximum fill line marked inside the pool wall.
13. After inflation, the blower should run continuously while children are playing.
Fig. A1 Fig. A3
Fig. A4 Fig. A5 Fig. A6
Fig. A7 Fig. A8 Fig. A9 Fig. A10
SETUP