Operating instructions

e
STATION
-
!
!
- 17 -
Charging Pb battery
PROGRAM SELECT
CH2>
LiPo
LiFe
LiIo
NiMH
NiCd
Pb
SETUP
REVIEW
Chg curr : 5.0A
Chg volt : Default
Chg mode : Linear
End curr : Auto
Max capa : 100%
Pb[ 1 ] 6S(12.0V)
12000mAh CHARGE
▶
You can choose a sub-program to be performed by pressing
‘MODE’ button, there are ‘CHARGE’ and ‘DISCHARGE’ programs.
And then select the data number will newly set up or load the data
already set up for re-use using ‘INC’ or ‘DEC’ buttons. If you have
the set-up data which had been performed successfully before,
you can just start the process. Set the cell-count and capacity of
the battery will be charged. The cell-count (or, voltage) and
capacity need to be identical with the battery. Use ‘UP/DOWN’
buttons to scroll up and down the menu, and change the value
using ‘INC/DEC’ buttons when the pertinent field is blinking.
To start the process, press and hold ‘START/ENTER’ button for
more than 3 seconds.
- Chg. curr. (Charge current) : Set the charge current. (0.1 ~
9.0A)
- Chg. mode (Charge mode) : Set the charge mode which the
charger will work with.
Linear; The charging current will be fed continuously without
hesitating. The battery is charged with pure ‘Direct-Current’.
Pulse; The charger will work with the parameters which were set
at the screen. The feeding current will be zero at every 30
seconds to have 3 seconds of waste-time for higher charging
efficiency.
▶
▶
This is programmed for charging Pb (lead-acid) battery with
nominal voltage from 2 to 28V. Pb batteries are totally
different from NiCd or NiMH batteries, but very similar with
Lithium batteries. They can only deliver relatively lower current
compare to their capacity, and similar restrictions definitely
apply to charge. So the optimal charge current will be 1/10 of
the capacity. Pb batteries must not be charged rapidly.
Always follow the instruction which was supplied by the battery manufacturer.
Select the output channel that the program will be performed by pressing ‘CHANNEL’ button and select
‘Pb’ program using UP/DOWN’ button. Press ‘START/ENTER’ button to enter the program.
Pb (lead-sulphuric acid) battery program
Chg curr : 5.0A
Chg volt : Default
Chg mode : Linear
End curr : Auto
Max capa : 100%
- Chg. volt (Charge volt) : Set the final charge voltage per cell.
The charger will charge the battery until the voltage has been
reached. The default values is 2.45V/cell. (2.20~2.50V/cell)
▶
Pb[ 1 ] 6S(12.0V)
12000mAh CHARGE
Pb[ 1 ] 6S(12.0V)
12000mAh CHARGE
Pb[ 1 ] 6S(12.0V)
12000mAh CHARGE
!
!
Chg curr : 5.0A
Chg volt : Default
Chg mode : Linear
End curr : Auto
Max capa : 100%
Chg curr : 5.0A
Chg volt : Default
Chg mode : Linear
End curr : Auto
Max capa : 100%
!