Product Manual

Page 7 of 17
2. Use a hammer to tap the handle pin into the holes of the pump bracket and handle (Figure 2).
Use pliers to turn the handle pin until its holes align with the spring pin holes.
3. Feed the screw head through the center hole in the handle pin (Figure 3). Using a screwdriver,
pry up the cam and slip the screw head under the notch in the cam.
4. Use a hammer to tap the spring pins (Figure 2) into the holes on the pump bracket and handle
pin.
5. Tap out the pump retainer pin (Figure 1).
Note: It’s a good idea to remove any air bubbles that might have accumulated in the hydraulic system
during shipping. Refer to ''Bleeding the Air'' in the upcoming Maintenance table.