Product Manual

Page 9 of 20
 Remove the screws from the two matching holes (1) on canopy. Loosen (do not remove) the
screws in the matching slots (2) on the canopy. Rotate the mounting bracket and remove from the
canopy.
 Install mounting bracket to the outlet box in the ceiling using the screws and the washers provided
with YOUR outlet box.
DOWNROD ASSEMBLY (included)
 Remove clamp pin (1) and cross pin (2) from down rod (3).
 Feed motor lead wires through downrod/canopy assembly and insert downrod into downrod yoke.
 Make sure to align hole in downrod with the hole in the yoke.
 Install yoke cross pin (1) through yoke and downrod.
 Insert clamp pin (2) into cross pin until it snaps securely into place.
 Tighten set screws (3) in yoke.
USING EXTENDED DOWNROD
(not included)