Product Manual

Page 10 of 20
 Loosen the downrod ball (1) from the downrod (2) by removing the screw (3).
 Slide downrod ball (1) off of downrod and remove pin (2).
DOWNROD PREPARATION
 Re-install pin into downrod.
 Slide the downrod ball up to the top of the downrod.
 Re-install the screw to secure ball to downrod.
Note: Some extended downrods have a pre-drilled set-screw hole. If a pre-drilled hole is present in
the extended downrod, tighten the set screw into the pre-drilled hole in the extended downrod.
 Tighten the screw against the downrod to secure the downrod ball.
HANGING ASSEMBLY
 Carefully lift fan assembly onto mounting bracket.
 Rotate fan until notch on downrod ball (1) engages the ridge of the mounting bracket (2). This