Product Manual
Page 7 of 12
Assembly Instructions
• Prior to mounting the hose reel, ensure that the supply line pressure does not exceed the
maximum working pressure of the hose reel.
• Unpack and inspect reel for damage. Turn by hand to check for a smooth operation.
• For wall mounting, install the reel five feet (1.5 meters) above the floor, at most.
• You will need to purchase appropriate hardware for mounting the reel.
• The reel base has four 10.5mm drilled holes for mounting on a suitable, flat surface.
• Using the four holes in the base, mount the reel in the desired location. Be sure to use
appropriate hardware and tighten securely.
• Apply Teflon tape or pipe sealant to the supply line threads. Attach to reel inlet and tighten it. The
other end of the incoming line can now be connected to a desired supply source.
• Apply Teflon tape or pipe sealant to the outlet fitting on the reel hose. Attach to a desired tool or
nozzle. Check the connection for leakage; also check hose reel for correct operation. See the
operation section.
• If a hose stopper adjustment is needed, pull the hose from the reel and allow latching at the
desired length. Loosen the stopper bolts and slide the stopper to a position close to the hose
guide. Tighten the stopper bolts and unlatch the reel.
Before Each Use
⚠WARNING
Check for damaged parts before each use. Replace damaged parts before continuing use.
Operating Instructions
⚠WARNING
Do not exceed the rated pressure of 90 PSI.
Do not point nozzle at people or animals.