Product Manual

Page 7 of 12
Assembly Instructions
• Prior to mounting the hose reel, ensure that the supply line pressure does not exceed the
maximum working pressure of the hose reel.
• Unpack and inspect the reel for damage. Turn the reel by hand to check for a smooth operation.
• For wall mounting, install the reel 5 feet (1.5 meters) above the floor, at most.
• You will need to purchase appropriate hardware for mounting the hose reel.
• The reel base has four 10.5mm drilled holes for mounting on a suitable flat surface.
• Using the four holes in the base, mount the reel in the desired location. Be sure to use
appropriate hardware and tighten securely.
• Apply Teflon tape or pipe sealant to the supply line threads. Attach to the reel inlet and tighten.
The other end of incoming line can now be connected to desired supply source.
• Apply Teflon tape or pipe sealant to the outlet fitting on the reel hose. Attach to the desired tool or
nozzle. Check the connection for leakage. Also, check the hose reel for correct operation. See
the operation section.
• If the hose stopper requires adjustment, pull the hose from the reel and allow latching at the
desired length. Loosen the stopper bolts and slide the stopper to a position close to the hose
guide. Tighten the stopper bolts and unlatch the reel.
Before Each Use
⚠WARNING
 Check for damaged parts before each use. Replace damaged parts before continuing use.
Operating Instructions
⚠WARNING
 Do not exceed the rated pressure of 90 PSI.
 Do not point nozzle at people or animals.