Product Manual

Page 10 of 15
Power Cord Selection
Section
Cord Length
2.0 mm
65.62 feet
3.5 mm
114.83 feet
Grounding
To prevent the risk of electric shock, the power plug must be plugged into a matching outlet and
grounded in good condition.
Switch Cord Connection
(1) Insert the switch plug into the switch receptacle of the hoist and tighten it by turning the locking
ring clockwise.
(2) To extend the length of the switch cord, add a switch extension cord (32.81 feet).
Before Each Use
⚠WARNING
Be sure to carefully check all safety and environmental conditions.
A minimum of five (5) wraps of wire rope wound around the drum is necessary. A wire rope should be
discarded and not be used again if it shows sign of excessive wear. Make sure to connect the main
power source and grounding. It’s not safe to lift loads exceeding the rated load. Only connect to a
power source that is the correct rated voltage otherwise malfunctioning could occur if the input voltage
falls above or below 10%.