Product Manual

Page 18 of 24
Automatic Use Assisted by Power Drill
1. You must use the power drill support base for safety reasons. Set up the hoist according to the
selected setting configuration
2. Insert the hex bit in the power drill chuck.
3. Adjust the power drill support base according to the power drill dimensions.
4. Insert the hex bit attached to the power drill, in the hex hole located in the middle of the steering
wheel. Turn the power drill to block it against the power drill support base. Set the power drill on
“maximum torque - low speed”, rotating in a clockwise direction.
POWER DRILL MINI 14.4 VOLT - 3 Ah
5. Pull the power drill trigger to lift the board.
6. To lower the top rack, remove the power drill first, and then push the main brake lever while
lifting up the safety brake latch.