User guide

Teaching Limits Using the Auto-Window Feature
Teaching the same limit twice automatically centers a 20 mm window on the
taught position.
General Notes on Programming
• The sensor returns to Run mode if the first TEACH condition is not regis-
tered within 120 seconds.
• After the first limit is taught, the sensor remains in Program mode until the
TEACH sequence is finished.
• To exit Program mode without saving any changes, press and hold the pro-
gramming push button for more than 2 seconds (before teaching the sec-
ond limit). The sensor reverts to the last saved program.
Output OFF Output ON Output OFF
Position
- 10 mm
Position
+ 10 mm
Position
- 10 mm
Taught Position
Output ON Output ON
Output OFF
Taught Position
Normally Closed Operation
Normally Open Operation
Position
+ 10 mm
Figure 4. Using the Auto-Window feature for pro-
gramming each output
Procedure
Result
Push Button (0.04 sec ≤ Click ≤ 0.8
sec)
Remote Line (0.04 sec < T < 0.8 sec)
Programming
Mode
Press and hold push button No action required; sensor is ready for 1st
limit teach
Output LED: ON Red
Power LED: ON Green (good signal) or ON
Red (no signal)
Teach First
Limit
Position the target for the first limit Position the target for the center of the
window
Power LED: Must be ON Green
"Click" the push button Single-pulse the remote line
T
Teach Accepted
Output LED: Flashing Red
Teach Unacceptable
Output LED: ON Red
Re-Teach
Limit
Without moving the target, "click" the
push button again
Without moving the target, single-pulse
the remote line again
T
Teach Accepted
Output LED: Yellow or OFF
Teach Unacceptable
Output LED: Flashing Red
Output OFF Output ON
Taught Position
(background surface)
Near
Range
Position
-10 mm
Position
+10 mm
Sensor
Output
ON
Sensor
Output
OFF
Any object in this area will switch
the output, whether or not the object
returns a good signal to the sensor.
Sensing Distance
Figure 5. An application for the Auto-Window feature (retroflective mode)
WORLD-BEAM QS18U Ultrasonic Sensors
P/N 119287 Rev. H www.bannerengineering.com - tel: [phone]