Owner manual

Extension Cables (without connectors)

The following cables are available for extending the length of existing sensor cable. These are 30 m (100') lengths of VALU-BEAM cable.

This cable may be spliced to existing cable. Connectors, if used, must be customer-supplied.

Model Type Used With:

EC312-100 4-conductor SM912 Series dc sensors

EC312A-100 2-conductor For all emitters and SM2A912 Series ac sensors

Retroreflective Targets

Banner offers a wide selection of high-quality retroreflective targets. See the Acces-

sories section of your current Banner Photoelectric Sensors catalog for complete in-

formation.

NOTE: Polarized sensors require corner cube type ret-

roreflective targets. Non-polarized sensors may use any

retroreflective target.

Replacement Lens Assemblies

VALU-BEAM lens assemblies are field-replaceable. In addition, some lenses may be used to convert from one sensing mode to another,

or to change the sensing range of a particular sensor. The possible conversions are listed in the table below.

Models Description Possible Sensing Mode or Range Changes

UC-900AG Replacement lens for LVAG Change LV to LVAG

UC-900C Replacement lens for C and CV Change LV to CV

UC-900DSR Replacement lens for DSR, ESR, and RSR Change D or F to DSR, EF to ESR, and RF to RSR

UC-900F Replacement lens for F Change D to F and DSR to F

UC-900FP Replacement lens for FP –

UC-900L Replacement lens for E, R, LV, and D Change LVAG to LV, CV to LV, DSR to D, and F to D

UC-900J Attach to E, R, ESR, RSR, LV, and D models Flat polycarbonate dust cover

VALU-BEAM® 912 Series

P/N 03467_web

Rev. F