Owner's manual

ManualsBrandsBanner ManualsSensorsU-GAGE T30UX Ultrasonic Sensors

Ultrasonic Sensor with TEACH-Mode Configuration

• 1, 2 and 3 m (3.28, 6.56, and 9.84 ft) versions with short dead zones (10% of

max range)

• Built-in temperature compensation

• Fast, easy-to-use TEACH-Mode programming; no potentiometer adjustments

• Remote TEACH for security and convenience

• Wide operating temperature range of −40° to +70° C (−40° to +158° F)

• Outputs can be set for either NPN (sinking) or PNP (sourcing), Normally Open

(N.O.) or Normally Closed (N.C.)

• Compact, self-contained, right-angle sensor package with fully encapsulated

electronics

ULTRASONIC

Models

Models Range and Frequency Cable

Supply Voltage Discrete Output Response Time

T30UXDA

100 mm to 1 m (3.9 in to 39 in)

224 kHz

Standard 2 m

(6.5 ft) cable

10 to 30V dc

NPN, PNP, NO,

NC, Selectable

45 ms

T30UXDB

200 mm to 2 m (7.8 in to 78 in)

174 kHz

92 ms

T30UXDC

300 mm to 3 m (11.8 in to 118 in)

114 kHz

135 ms

WARNING: Not To Be Used for Personnel Protection

Never use this device as a sensing device for personnel protection. Doing so could lead to serious

injury or death. This device does not include the self-checking redundant circuitry necessary to allow its

use in personnel safety applications. A sensor failure or malfunction can cause either an energized or de-

energized sensor output condition.

Only standard 2 m (6.5 ft) cable models are listed. For 4-Pin Euro-Style integral QD, add suffix “Q8” to the model number (for example, T30UXDAQ8). For 150 mm (6 in) PUR pigtail

cable with 4-Pin threaded Euro-Style QD, add suffix “QPMA” to the model number (for example, T30UXDAQPMA). For 9 m (30 ft) cable, add suffix “W/30” to the model number (for

example, T30UXDA W/30). A model with a QD connector requires a mating cable; see Quick-Disconnect Cables on page 11.

U-GAGE® T30UX Series with Discrete Output

P/N 138381_web

Rev. G

8/19/2013

Summary of content (12 pages)

PAGE 1
U-GAGE® T30UX Series with Discrete Output Ultrasonic Sensor with TEACH-Mode Configuration • 1, 2 and 3 m (3.28, 6.56, and 9.84 ft) versions with short dead zones (10% of max range) • Built-in temperature compensation • Fast, easy-to-use TEACH-Mode programming; no potentiometer adjustments • Remote TEACH for security and convenience • Wide operating temperature range of −40° to +70° C (−40° to +158° F) • Outputs can be set for either NPN (sinking) or PNP (sourcing), Normally Open (N.O.
PAGE 2
U-GAGE® T30UX Series with Discrete Output Overview The U-GAGE® T30UX is an easy-to-use ultrasonic sensor with extended range and built-in temperature compensation. Simple push button configuration provides flexibility for a variety of applications. Easy-to-see indicator LEDs communicate the status of the sensor. The Green “Power” LED ON indicates that the sensor is in Run Mode (the sensor’s normal operating condition). The Red “Signal” LED indicates the target signal strength.
PAGE 3
U-GAGE® T30UX Series with Discrete Output The sensor may be configured either via its push button, or via a remote switch. Remote configuration also may be used to disable the push button, preventing unauthorized personnel from adjusting the configuration settings. To access this feature, connect the white wire of the sensor to 0V dc, with a remote configuration switch between the sensor and the voltage. Configuration is accomplished by following the sequence of input pulses.
PAGE 4
U-GAGE® T30UX Series with Discrete Output Normally Open Operation Minimum Limit Output OFF Maximum Limit Output ON Output OFF Normally Closed Operation Minimum Limit Output ON Maximum Limit Output OFF Output ON Figure 2. Teaching independent minimum and maximum limits Push Button Remote Line 0.04 sec. < “click” < 0.8 sec. 0.04 sec. < T < 0.8 sec.
PAGE 5
U-GAGE® T30UX Series with Discrete Output Teaching Limits Using the Auto-Window Feature Teaching the same limit twice automatically centers a window on the taught position (see Figure 4. Window Size on page 5 for window sizes). General Notes on Teaching • The sensor will return to RUN mode if the TEACH condition is not registered within 120 seconds after the initial 2 second hold on the Discrete push button.
PAGE 6
U-GAGE® T30UX Series with Discrete Output Push Button 0.04 sec. < “click” < 0.8 sec. Procedure Remote Line 0.04 sec. < T < 0.8 sec. Result Procedure Result Power LED: ON Teach Not Accepted Output LED: Flashing Power LED: OFF Power LED: ON Teach Not Accepted Output LED: Flashing Power LED: OFF Taught Position (background surface) Near Range Sensor Output ON Any object in this area will switch the output, whether or not the object returns a good signal to the sensor.
PAGE 7
U-GAGE® T30UX Series with Discrete Output Run Mode Power LED ON, All other LEDs in normal operating condition 1x Exit No valid target TEACH MODE (1 st pulse teaches 1st limit) Power LED OFF, Output LED Flashing 2 s Hold 1x Teach 2nd limit No valid target Power LED ON Output LED ON or OFF (depending on NO or NC) 2x Output Configuration Menu Power LED OFF.
PAGE 8
U-GAGE® T30UX Series with Discrete Output Specifications Sensing Range “A” suffix models: 100 mm to 1 m (3.9 in to 39 in) “B” suffix models: 200 mm to 2 m (7.8 in to 78 in) “C” suffix models: 300 mm to 3 m (11.8 in to 118 in) Ultrasonic Frequency “A” suffix models: 224 kHz “B” suffix models: 174 kHz “C” suffix models: 114 kHz Supply Voltage 10 to 30V dc (10% max.
PAGE 9
U-GAGE® T30UX Series with Discrete Output Performance Curves With Plate Target (Typical) 1-Meter Models 2-Meter Models 200 mm 8.0" 400 mm 16.0" 400 mm 16.0" 150 mm 6.0" 300 mm 12.0" 300 mm 12.0" 4.0" 200 mm 8.0" 200 mm 2.0" 100 mm 4.0" 100 mm 100 mm 100 x 100 mm 50 mm Width 3-Meter Models 0 0 Width 100 x 100 mm 0 0 Width 100 x 100 mm 8.0" 4.0" 0 0 50 mm 2.0" 100 mm 4.0" 100 mm 4.0" 100 mm 4.0" 200 mm 8.0" 200 mm 8.0" 150 mm 6.0" 300 mm 12.0" 300 mm 12.
PAGE 10
U-GAGE® T30UX Series with Discrete Output Hookups NPN (Sinking) Output Selected 1 1 + 12-30V dc – 3 4 PNP (Sourcing) Output Selected 2 + 12-30V dc – 3 4 Load Load 2 Remote Programming (N.O.) Wiring Key 1 = Brown 2 = White 3 = Blue 4 = Black Remote Programming (N.O.) Shield* Shield* * It is recommended that the shield wire be connected to either earth ground or DC common. * It is recommended that the shield wire be connected to either earth ground or DC common.
PAGE 11
U-GAGE® T30UX Series with Discrete Output Quick-Disconnect Cables 4-Pin Threaded M12/Euro-Style Cordsets with Shield Model Length Style MQDEC2-406 1.83 m (6 ft) Straight MQDEC2-415 4.57 m (15 ft) MQDEC2-430 9.14 m (30 ft) MQDEC2-406RA 1.83 m (6 ft) MQDEC2-415RA 4.57 m (15 ft) MQDEC2-430RA 9.14 m (30 ft) Dimensions Pinout 44 Typ. M12 x 1 ø 14.5 Right-Angle 2 1 3 4 32 Typ. [1.26"] 1 = Brown 2 = White 3 = Blue 4 = Black 30 Typ. [1.18"] M12 x 1 ø 14.5 [0.
PAGE 12
U-GAGE® T30UX Series with Discrete Output Bolt thread: SMB30FA, A= 3/8 - 16 x 2 in; SMB30FAM10, A= M10 - 1.5 x 50 Hole size: B= ø 30.1 Banner Engineering Corp Limited Warranty Banner Engineering Corp. warrants its products to be free from defects in material and workmanship for one year following the date of shipment. Banner Engineering Corp.