Owner manual

Banner Engineering Corp.•Minneapolis,MNU.S.A
www.bannerengineering.com•Tel:763.544.3164
2 P/N 129323 rev. E
SureCross™ DX80K Wireless Configured FlexPower™ Kit
Gateway as
Repeater
DI1
DO1
GND
SP3
GND
A1+
A1−
SP1
DI2
DO2
GND
SP4
GND
A2+
A2−
SP2
I/O
Point
Terminal Block
Label
DX80 Node 1 DX80 Node 2 Terminal Block
Label
I/O
Point
9 DO1 Discrete OUT 1 Discrete IN 1 DI1 1
10 DO2 Discrete OUT 2 Discrete IN 2 DI2 2
13 AO1 Analog OUT 1 Analog IN 1+ A1+ 3 QT50U*
14 AO2 Analog OUT 2 Analog IN 2+ A2+ 4
These are the I/O points as displayed on the device LCD. Any I/O points not shown in the chart are not enabled for this kit.
*Thiskitisoptimizedforusewiththespecial,low-powerQT50UUltrasonicsensor.
Configured input/output mapping
Hookup Diagrams
QT50UPower
Sinking Input Wiring Sinking Output Wiring
AOx
GND
+10 to 30V dc
Analog (Sourcing) Output Wiring
Analog (Sourcing) FlexPower Input Wiring
(switch powered device)
A1+
SP1
*
* Do not exceed analog input ratings for analog
inputs. Only connect sensor outputs to analog inputs.
+10 to 30V dc
Ax+
GND
*
dc common
* Do not exceed analog input ratings for analog
inputs. Only connect sensor outputs to analog inputs.
Analog (Sourcing) FlexPower Input Wiring
(externally powered device)
PWR
GND
AO2
AI2
PWR
GND
DO2
DI2
PWR
GND
AO1
AI1
PWR
GND
DO1
DI1
DOx
GND
DIx
GND
5-pin Euro-style Hookup (RS-485)
Wire Color Gateway 10–30V dc Node FlexPower Node**
1 Brown +10 to 30V dc Input +10 to 30V dc Input
2 White RS485/D1/B/+
3 Blue dc common (GND) dc common (GND) dc common (GND)
4 Black RS485/D0/A/−
5 Gray Comms grnd 3.6to5.5Vdc
 * Connectingdcpowertothecommunicationpinswillcausepermanentdamage.
** ForFlexPowerdevices,donotapplymorethan5.5Vdctothegraywire.