Manual

Wiring Diagrams for Analog Inputs
Connecting dc power to the communication pins will cause permanent damage. Do not exceed analog input ratings for analog inputs.
Only connect sensor outputs to analog inputs.
Analog Input Wiring (10 to 30V dc Pow-
er)
Analog Input Wiring (Externally Powered
Sensors)
Analog Input Wiring (Switch Powered
Sensors)
SureCross Device
dc common
external
power
AIx or Ax+
GND
SureCross Device
AIx or Ax+
SPx
(Only possible in models with switch power
(SPx) outputs)
Wiring Diagrams for Thermistor Inputs
A4
GND
SureCross Device
Wiring Diagrams for Discrete Outputs
Connecting dc power to the communication pins will cause permanent damage. For the DX8x...C models, PWR in the wiring diagram
refers to V+ on the wiring board and GND in the wiring diagram refers to V- on the wiring board.
Discrete Output Wiring (NPN or NMOS)
DOx
PWR or SPx
SureCross Device
Additional Information
For additional information, including installation and setup, weatherproofing, device menu maps, troubleshooting, and a list of accesso-
ries, refer to one of the following product manuals
SureCross Quick Start Guide: Banner part number 128185
SureCross Wireless I/O Network Manual: 132607
Web Configurator Manual (used with "Pro" and DX83 models): 134421
SureCross DX80 FlexPower Solar Node
4 www.bannerengineering.com - tel: 763-544-3164 P/N 140373 rev. B