Manual

Banner Engineering Corp. • Minneapolis, MN U.S.A.

www.bannerengineering.com • Tel: 763.544.3164

SureCross Wireless Network

Product Manual

Introduction

Features

DX80 Gateway and Node

1. Port, NPT Gland, or Plug If unused, install the provided plug into the 1/2 NPT threaded port. Refer to the Installation section if an IP67

seal is required.

2. Rotary Switch 1 (left) Sets the Network ID (NID) to a hexidecimal value from 0 to F, for a total of 16 Network IDs. A Gateway and its

corresponding Nodes must be assigned the same Network ID.

Rotary Switch 2 (right) Gateway: Sets the Gateway’s LCD viewing device address. The Gateway is predefined as Device Address 0.

Node: Sets the Node’s Device Address (hexidecimal 1 to F). Each Node within a network must have a unique

Node Device Address.

3. Push Button 1 Single-click to advance across all top-level DX80 menus.

Single-click to move down interactive menus, once a top-level menu is chosen.

4. Push Button 2 Double-click to select a menu and to enter manual scrolling mode.

Double-click to move up one level at a time.

5. LED 1 and 2 Provide real-time feedback to the user regarding RF link status, serial communications activity, and the error

state.

6. LCD Display Six-character display provides run mode user information and shows enabled I/O point status. This display

allows the user to conduct a Site Survey (RSSI) and modify other DX80 configuration parameters without the

use of a PC or other external software interfaces. On the Node, after 15 minutes of inactivity, the LCD goes

blank. Press any button to refresh the display.

7. 5-Pin M12 Euro-style quick-disconnect serial port