Owner's manual
I/O Point Modbus Holding Register I/O Type
Gateway Any Node
2 2 2 + (Node# × 16) Serial device 1, primary input 2; OR Discrete IN 3 0h01
3 3 3 + (Node# × 16) Serial device 1, primary input 3; OR Discrete IN 1 0h02
4 4 4 + (Node# × 16) Serial device 1, secondary input 1; OR Serial device 2, primary input 1 0h03*
0h00
5 5 5 + (Node# × 16) Serial device 1, secondary input 2; OR Serial device 2, primary input 2; OR Dis-
crete IN 4
0h04*
0h01
6 6 6 + (Node# × 16) Serial device 1, secondary input 3; OR Serial device 2, primary input 3; OR Dis-
crete IN 2
0h05*
0h02
7 7 7 + (Node# × 16) Reserved
8 8 8 + (Node# × 16) Device Message
9 9 9 + (Node# × 16) Serial device 1, primary output 1 0h00
10 10 10 + (Node# × 16) Serial device 1, primary output 2 0h01
11 11 11 + (Node# × 16) Serial device 1, primary output 3 0h02
12 12 12 + (Node# × 16) Serial device 1, secondary output 1; OR Serial device 2, primary output 1 0h03*
0h00
13 13 13 + (Node# × 16) Serial device 1, secondary output 2; OR Serial device 2, primary output 2 0h04*
0h01
14 14 14 + (Node# × 16) Serial device 1, secondary output 3; OR Serial device 2, primary output 3 0h05*
0h02
15 15 15 + (Node# × 16) Control Message
16 16 16 + (Node# × 16) Reserved
* Based on DIP switch settings.
Specifications
Radio and General
Range
900 MHz: Up to 4.8 kilometers (3 miles)
2.4 GHz: Up to 3.2 kilometers (2 miles)
Transmit Power
900 MHz: 21 dBm (150 mW) conducted
2.4 GHz: 18 dBm (65 mW) conducted, less than or
equal to 20 dBm (100 mW) EIRP
900 MHz Compliance (150 mW Radios)
FCC ID TGUDX80 - This device complies with FCC
Part 15, Subpart C, 15.247
IC: 7044A-DX8009
2.4 GHz Compliance
FCC ID UE300DX80-2400 - This device complies with
FCC Part 15, Subpart C, 15.247
ETSI/EN: In accordance with EN 300 328: V1.7.1
(2006-05)
IC: 7044A-DX8024
Power
Requirements: +10 to 30V dc or +3.6 to 5.5V dc low
power option (Outside the USA: +12 to 24V dc, ±10%
or +3.6 to 5.5V dc low power option)
Consumption: Less than 1.4 W (60 mA) at 24V dc
Housing
Polycarbonate housing and rotary dial cover; polyester
labels; EDPM rubber cover gasket; nitrile rubber, non-
sulphur cured button covers
Weight: 0.26 kg (0.57 lbs)
Mounting: #10 or M5 (SS M5 hardware included)
Max. Tightening Torque: 0.56 N·m (5 lbf·in)
Antenna Connection
Ext. Reverse Polarity SMA, 50 Ohms
Max Tightening Torque: 0.45 N·m (4 lbf·in)
SureCross DX80 FlexPower Serial Interface Node
6 www.bannerengineering.com - tel: 763-544-3164 P/N 136971 Rev. G