Owner's manual

Sample and Report Rates
The sample interval, or rate, defines how often the SureCross device samples the input. For battery-powered applications, setting a slow-
er rate extends the battery life.
The report rate defines how often the Node communicates the I/O status to the Gateway. Change of state reporting sets the system to
report only when the value crosses the threshold setting. For FlexPower™ applications, setting the report rate to a slower rate extends
the battery life.
Wiring Your SureCross® Device
Use the following wiring diagrams to first wire the sensors and then apply power to the SureCross devices.
5-pin Euro-Style Wiring (Nodes)
Wiring the 5-pin Euro-style connector depends on the model and power requirements of the device. Connecting dc power to the commu-
nication pins will cause permanent damage. For FlexPower devices, do not apply more than 5.5V to the gray wire.
Wire No. Wire Color 10 to 30V dc Powered Nodes Battery Powered Nodes
1
2
3
4
5
1 Brown 10 to 30V dc
2 White
3 Blue dc common (GND) dc common (GND)
4 Black
5 Gray 3.6 to 5.5V dc
DX80...C Wiring
Wiring power to the DX80...C models varies depending the power requirements of the model. Connecting dc power to the communication
pins (Tx/Rx) will cause permanent damage. For FlexPower devices, do not apply more than 5.5V to the gray wire.
Terminal Label Gateway, DX85 10 to 30V dc Powered Nodes Battery Powered Nodes
V+ 10 to 30V dc 10 to 30V dc
Tx/+ RS485 / D1 / B / +
V- dc common (GND) dc common (GND) dc common (GND)
Rx/- RS485 / D0 / A / -
B+ 3.6 to 5.5V dc
Terminal Block (IP67 Housing)
For the IP67 housing models, PWR in the wiring diagram refers to SP1 or SP2 on the wiring board.
SP2
CMB
DO2
DO4
GND
DI1
DI4
SP1
CMA
DO1
DO3
GND
DI1
DI3
GND GND
CMx. Serial interface connection. For non-serial interface models, do not make
any wiring connections to these terminals.
DIx. Discrete IN x.
DOx. Discrete OUT x.
GND. Ground/dc common connection.
SPx. Switch Power. Provides variable power sources for external devices.
Ignore alternate labeling referring to other models that use this board.
SureCross DX80 FlexPower Serial Interface Node
4 www.bannerengineering.com - tel: [phone] P/N 136971 Rev. G