Manual

SL0 Series Slot Sensor
page 3
Banner Engineering Corp. • Minneapolis, U.S.A.
Website: http://www.baneng.com • Tel: [phone]
Figure 3. SL0 Series Slot Sensor dimensions
M12 x 1
Signal LED
(Yellow)
Power LED
(Green)
20.2 mm (0.80")
18.8 mm
(0.74")
6.0 mm
(0.24")
2x ø5.6 mm
(0.22")
6.0 mm
(0.24")
10.9 mm
(0.43")
10.0 mm
(0.39)
30.2 mm
(1.19")
45.0 mm
(1.77")
72.0 mm
(2.84")
40.0 mm
(1.58")
52.0 mm
(2.05")
SL0 Series Slot Sensor Specifications
Slot Opening 30 mm (1.2") wide x 45 mm (1.8") deep overall; beam set in 10 mm (0.4") from outer edge
Supply Protection Circuitry Protected against reverse polarity and transient voltages
Output Configuration Bipolar: NPN (current sinking) and PNP (current sourcing)
Output Rating 150mA, each output
Output Protection Circuitry Protected against false pulse on power-up and short-circuit of outputs
Output Response Time 1 millisecond or 300 microseconds, depending on model
Repeatability 250 microseconds or 75 microseconds, depending on model
Adjustments None
Indicators Green: Power ON/OFF indicator
Yellow: Signal Condition indicator
Construction Housing: ABS/polycarbonate
Lenses: Acrylic
Environmental Rating IP67, NEMA 6
Connections 2 m (6.5') or 9 m (30') 5-conductor PVC-jacketed attached cable or 5-pin Euro-style quick-disconnect
(QD) connector. QD cables are ordered separately; see page 4.
Operating Conditions Operating Temperature: -40° to +70°C (-40° to +158°F)
Maximum relative humidity: 90% @ 50°C (non-condensing)
Supply Voltage and Current 10 to 30V dc, 30 mA
SL0 Series Slot Sensor Hookups
bn
bu
wh
bk
gy
+
10 - 30V dc
–
Load
Load
(See right*)
Cabled models
bn
bu
wh
bk
gy
+
10 - 30V dc
–
Load
Load
(See left*)
Quick-Disconnect models
*For Dark Operate, connect gray wire
to + (brown).
For Light Operate, connect gray wire
to – (blue) or leave circuit open.