Manual

P/N 27988 Rev. C 3
Banner Engineering Corp. • Minneapolis, MN U.S.A
www.bannerengineering.com • Tel: [phone]
Q08 Series Opposed-Mode Sensors
Specifications
Supply Voltage and Current 10 to 30V dc at 30 mA total maximum; 15 mA for emitter, 15 mA for receiver (exclusive of load)
10% maximum ripple
Supply Protection Circuitry Protected against reverse polarity
Output Configuration Solid-state dc output, with four output types available:
NPN sinking/light operate PNP sourcing/light operate
NPN sinking/dark operate PNP sourcing/dark operate
Light operate outputs conduct when the receiver sees the emitter’s pulse-synchronized light source;
Dark operate outputs conduct when the receiver does not see the emitter’s pulse-synchronized source.
Output Rating 150 mA maximum, continuous
Off-state leakage current is 100 microamps at 30V dc
On-state saturation voltage is < 200 millivolts at 10 mA dc and < 1 volt at 150 mA dc
Output Protection Circuitry Protected against false pulse on power-up and continuous overload or short circuits of outputs.
Overloadtrippoint≥220mA,typical,at20°C.
Output Response Time 1 millisecond ON and OFF independent of signal strength
Repeatability 200 microseconds (0.2 milliseconds), independent of signal strength
Indicators Two LED indicators:
Green: Lights to indicate dc power ON
Yellow: Lights (except opposed emitters) when sensor output is conducting (in “light” condition for light operate
models; in “dark” condition for dark operate models)
Construction Black epoxy-painted die-cast zinc housing, polysulfone thermoplastic lens with two through-mounting holes
to accommodate M3 (#4) hardware
Environmental Rating Meets NEMA standards 1, 2, 4, 6, 12 and 13; IEC IP67
Connections PVC-jacketed 2 m (6.5’) or 9 m (30’) cable. Cable is 4.0 mm (0.16”) in diameter.
Operating Conditions Temperature:0°to+50°C(+32°to+122°F)
Maximumrelativehumidity:90%at50°C(non-condensing)
Certifications
Wiring Diagrams
bu
wh
bn
+
–
bk
10-30V dc
Load
+
–
Tie black wires
together
bu
bn
bk
Receiver Emitter
bn
wh
bu
+
–
bk
10-30V dc
Load
Tie black wires
together
bn
bu
bk
Receiver Emitter
+
–
Emitter and NPN (Sinking) Receiver Emitter and PNP (Sourcing) Receiver