User guide
• Location of all shapes found
Note: If the Geometric Count tool is preceded by a Location tool (for example, Locate or
Geometric Find tool), then the Search ROI will only translate by the amount that the preceding
Location tool found. Thus, even if the Location tool has rotation enabled, the Search ROI will not
rotate.
Note: The Geometric Count tool requires strong and repeatable edge content in the image.
Usage
• Verify date/lot codes
• Inspect electronic component assembly
• Inspect printing
Fields
The following are fields on the Geometric Count tool Input tab:
•
Threshold7.2.2.2 Threshold on page 113
•
Enabling Remote Teach7.4.5.3 Enabling Remote Teach on page 167
•
Count7.3.1.4 Count on page 113
•
Edge Length7.2.2.3 Edge Length on page 114
•
Legend7.2.2.4 Legend on page 114
•
Results7.2.2.5 Results on page 117
Supported Platforms
BCR/BCR
1.3
GEO/GEO
1.3
EDGE/EDGE
1.3
AREA/AREA1.3OMNI/OMNI
1.3
OMNI ColorProII/ProII
1.3
ProII Color
NoYesNoNoYesYesYesYes
Geometric Count Tool Input Tab
111Banner Engineering Corp. - Minneapolis, MN USA - www.bannerengineering.com
Tel: 763.544.3164
P/N 000000
PresencePLUS Software Tools7/2009