User guide

Note: If the Geometric Find tool is preceded by a Location tool (for example, a Locate or another
Geometric Find tool), the Search ROI will translate by the amount that the preceding Location
tool found. However, even if the Location tool has rotation enabled, the Search ROI will not
rotate.
Note: The Geometric Find tool requires strong and repeatable edge content in the image.
Usage
• Locate the position of a label
• Locate electronic components on a circuit board
• Locate date/lot code for inspection
Note: In general, the Geometric Find tool can be used to locate a rounded object or an object
where large amounts of rotation are possible. In these types of applications, a linear Locate tool
will not work as well.
Fields
The following are fields on the Geometric Find tool Input tab:
•
Threshold7.2.2.2 Threshold on page 113
•
Edge Length7.2.2.3 Edge Length on page 114
•
Legend7.2.2.4 Legend on page 114
•
Results7.2.2.5 Results on page 117
Supported Platforms
BCR/BCR
1.3
GEO/GEO
1.3
EDGE/EDGE
1.3
AREA/AREA1.3OMNI/OMNI
1.3
OMNI ColorProII/ProII
1.3
ProII Color
NoYesNoNoYesYesYesYes
Geometric Find Input Tab
P/N 000000Banner Engineering Corp. - Minneapolis, MN USA - www.bannerengineering.com
Tel: [phone]
104
7/2009PresencePLUS Software Tools