Owner's manual

Adding a Linear Tool
To add a tool to an inspection:
DescriptionField/Button
Use this field to rename the tool. The default is tool_name_1, tool_name_2,
and so on, where the default tool_name depends on the tool being created
(for example, locate, edge or the like). The name can have only alphanumeric
characters and underscores with no spaces.
Click this button to add an ROI to an image.
Click this button to remove an ROI from an image.
P/N 000000Banner Engineering Corp. - Minneapolis, MN USA - www.bannerengineering.com
Tel: [phone]
112
7/2009PresencePLUS Software Tools