Owner manual

Main Tasks to CompleteStep 1

3. Scroll down to the Coordinate Tool, and then select the checkbox next to it, as shown

below.

4. Click the OK button to close the Tool Conﬁguration dialog.

Main Tasks to CompleteStep 2

Create a New

Inspection using Setup.

1. In the PresencePLUS GUI, create a new inspection by pressing the Setup button in the

upper-left corner of the GUI.

2. Capture an image of the part to locate.

3. Press the Goto Tools button in the lower-right corner of the Setup tab.

Main Tasks to CompleteStep 3

Add a Geometric

Find tool to locate the

1. In the PresencePLUS GUI, click the Location Tools tab.

part within the

ﬁeld-of-view.

Banner Engineering Corp.Minneapolis, MN USA66

2/2010System Setup Dialog