Owner manual

Serial Connection
The sensor has a single serial connection that you can configure, Serial 1:
• Serial 1 is the DB-9 connector.
Note: The Pro has 2 serial connections. Serial 2 in the dropdown list is to support those sensors.
The sensor has one serial connection that can be configured: Serial 1 is pins 1, 9, and 10. Set up the serial communication
options to match the receiving device. The following table shows the configuration options:
Default SettingAttribute
115200Baud Rate
8Data Bits
NoneParity
1Stop Bit
NoneFlow Control
To setup a serial connection:
1. Click on the System button in the Main Menu toolbar to bring up the System Setup window.
2. Click on the Communication tab.
3. Choose Serial 1 from the Connection drop-down list of the Communication Tool Setup field.
Banner Engineering Corp.Minneapolis, MN USA52
2/2010System Setup Dialog