Owner manual

• If the current value falls outside the Test tool’s set tolerance or if the tool failed to execute properly, then a red failed
symbol is shown beside that parameter.
DescriptionParent LevelLevelName
Name of currently running inspection.NoneFirstCurrent Inspection
Sensor Information:Inspection NameSecondThe Camera
• Gain
• Exposure time (ms)
Trigger Input Information:Inspection NameSecondThe Trigger
• Divide
• Delay
• Width
• Polarity
General Inspection Information:Inspection NameSecondThe Inspection
Manager
• Fail hold time (ms): how long a failed image is
displayed on the monitor
• Power-up time: time since last shutdown (resolution
= second)
• Pass count
• Fail count
• Missed trigger count: total number of triggers
missed because sensor was not Ready
• Lifetime: ow long the sensor has been turned on
(resolution = 1 hour)
Banner Engineering Corp.Minneapolis, MN USA342
2/2010Run Screen