Owner manual

Each numbered circle represents an output and its current state.
The legend below applies to the colored circles in the outputs:
• Gray = Inactive (not currently available)
• Red = Active (not currently available)
• Not Visible = Not selected as input/output
10.7 Product Select
Displays the last latched Product Select (binary encoded).
The legend below applies to the colored circles in the outputs:
• Gray = Inactive (not currently available)
• Red = Active (not currently available)
• Not Visible = Not selected as input/output
10.8 System
E = System error
R = Ready
Note: The results of the discrete I/O are not displayed in real time. They update approximately 4 times per second.
10.9 Start/Stop
Click the Start button to start running the inspection and click Stop to stop running the inspection.
10.10 Select Tab
The fields on the Select tab of the Run screen are described below.
Product Select
• The Hardware Input option signals the sensor to run the product option currently selected by the Product and Product
Select input lines (not necessarily what is shown in the drop-down list on the tab). With this option selected, then,
the Product Change and Product Select input will change the inspection when signaled to do so.
• The Software Override option is typically used for troubleshooting a specific inspection and it signals the sensor
that you will manually select an inspection to run. The inspection displayed in the field next to Software Override
will be the inspection that runs.
Banner Engineering Corp.Minneapolis, MN USA338
2/2010Run Screen