Owner manual

Note: The following addresses are defaults.

PortDefault IP AddressSocket

20000192.168.0.11

20001192.168.0.12

20002192.168.0.13

20003192.168.0.14

20004192.168.0.15

20005192.168.0.16

20006192.168.0.17

20007192.168.0.18

20008192.168.0.19

20009192.168.0.110

8.2 Serial Connection

The sensor has a single serial connection that you can conﬁgure, Serial 1:

• Serial 1 is the DB-9 connector.

Note: The Pro has 2 serial connections. Serial 2 in the dropdown list is to support those sensors.

The sensor has one serial connection that can be conﬁgured: Serial 1 is pins 1, 9, and 10. Set up the serial communication

options to match the receiving device. The following table shows the conﬁguration options:

Default SettingAttribute

115200Baud Rate

8Data Bits

NoneParity

1Stop Bit

NoneFlow Control

To setup a serial connection:

1. Click on the System button in the Main Menu toolbar to bring up the System Setup window.

2. Click on the Communication tab.

3. Choose Serial 1 from the Connection drop-down list of the Communication Tool Setup ﬁeld.

Banner Engineering Corp.Minneapolis, MN USA318

2/2010Communication Tool Setup