Owner manual

Examples
Assuming that you have two Math tools, my_math_tool_1 and my_math_tool_2, each
with their first operand configured as a constant. To set the constant of the second mathtool
to 100.5, issue the following command:
set mathtool my_math_tool_2 operand_1 100.5
Set Command
Example
or
set mathtool 2 operand_1 100.5
To get the constant of the second mathtool, issue the following command:
get mathtool my_math_tool_2 operand_1
Get Command Example
or
get mathtool 2 operand_1
7.6.4 Measure Tool
Measure tool can be used to measure distance, calculate angles, and create points and lines for use as inputs to other
Measure Tools.
There are three Measure Tool operations:
• Measure from a point to a point
• Intersect two lines
• Measure from a line to a point
• Measure a curve to a point
• Measure a curve to a line
In these operations, points are generated by a variety of vision tools and lines are created by Coordinate tools, Line
Detect tools, or other Measure tools.
Usage
• Determine the location of a Blob
• Determine the distance between Blobs
• Determine a distance between a Blob and a closest point on a bead
• Determine a distance between a Blob and a farthest point on a bead
Fields
The following are fields on the Measure tool Input tab:
• Measure Tool Operations on page 269
• Measurement Type on page 277
Supported Platforms
BCR/BCR
1.3
GEO/GEO
1.3
EDGE/EDGE
1.3
AREA/AREA1.3OMNI/OMNI
1.3
OMNI
Color
ProII/ProII
1.3
ProII Color
YesYesYesYesYesYesYesYes
Banner Engineering Corp.Minneapolis, MN USA268
2/2010PresencePLUS Software Tools