Owner manual

Additional InformationDescriptionEnhanced
Character Settings
Box Width unless the
Oversized characters has
Discard selected, in which case,
for example, a 5 pixel character
will be ignored.
If a box reaches the Max Box
Width without finding a natural
character ending, when Enable
Adaptive Max Box Width is
checked, the senor will adjust
the right edge of the box to find
a most likely endpoint for a
character.
Enable Adaptive
Max Box Width
Undersized
characters
• When Discard is selected, the
sensor will reject proposed
boxes that do not meet the
minimum requirements (see
Minimum Box Width above).
• When Extend is selected, the
sensor will make the character
fit the box.
Oversized
characters
• When Discard is selected, the
sensor will reject proposed
boxes that do not meet the
maximum requirements (see
Maximum Box Width above)
.
• When Split is selected, the
sensor will split the character
into multiple characters.
Character Connectivity Calibration
Intra-Character Connectivity defines the maximum number of pixel spaces between two character strokes so that both
strokes will be considered part of the same character. In the example below, if the Horizontal Gap were defined too
small, the "H" could be considered an I - I.
Banner Engineering Corp.Minneapolis, MN USA234
2/2010PresencePLUS Software Tools