User guide

PSC-24 Power Supplies (24 Volt)
PSC-24 Models
80.0 mm
(3.15")
1.8 m
(6.0')
165.0 mm
(6.50")
54.0 mm
(2.13")
Printed in USA 05/01 P/N 67446
WARRANTY: Banner Engineering Corp. warrants its products to be free from defects for one year. Banner Engineering Corp. will repair or replace, free of
charge, any product of its manufacture found to be defective at the time it is returned to the factory during the warranty period. This warranty does not cover
damage or liability for the improper application of Banner products. This warranty is in lieu of any other warranty either expressed or implied.
Features
• 24V dc power supply delivers up to 2.2 amps
• Designed to power Banner model SCM strobe control module (see data sheet
p/n 67448)
• Choose model with 120V ac North American power cord, or with 220V ac Euro
power cord
• Tough ABS housing
Environmental Rating IEC IP20; NEMA 1
Operating Conditions Temperature: 0° to 40°C (+32° to 104°F)
Maximum relative humidity: 95% at 40°C (non-condensing)
Models Input
Input
Cord Output
Output
Cable Used with
PSC-24E
†
PSC-24
†
100-250V ac
50/60 Hz
1.0A (RMS) for 120V ac
0.5 A (RMS) for 240V ac
North America
(NEMA 5-15)
24V dc ±5%
with voltage
regulation of ±1%
2.2 A max.
1.8 m (6')
2-wire cable
(no connector)
SCM
Strobe Control
Module
Cont. Europe
(Schuko CEE 7)
†
These models are not stocked and are non-returnable.
Banner Engineering Corp., 9714 Tenth Ave. No., Mpls., MN 55441 • Ph: 763.544.3164 • www.bannerengineering.com • Email: [e-mail]