Owner's manual

Printed in USA 07/06 P/N 128190

Model PPLIM Light Interface Module

DC-Powered Interface for PresencePLUS

Lights

Features

• Low-cost strobe interface between user’s hardware and PresencePLUS lights

• Separate Strobe Signal inputs:

– 5V TTL signal

– 8–30V dc signal (switch-selectable current sinking/NPN or current sourcing/PNP)

• Two Light Strobe outputs:

– 5V “Active Low” (non-inverting)

– 5V “Active High” (inverting)

• LED indicators for Power and Strobe Signal inputs

• Easy-to-adjust 45° screw terminals for electrical wiring

• Simple 35 mm DIN-rail-mount or wall-mount configuration

Overview

The model PPLIM PresencePLUS Light Interface Module is a passive DIN-rail-mount or

wall-mount module. It enables use of Banner PresencePLUS LED lights with strobe signal

sources other than Banner machine vision sensors, for example, high-end vision systems,

PLCs, photoelectric sensors, or proximity sensors.

Installation

For mounting to a flat surface, unscrew one end cap, slide the DIN clips off of the

housing, and replace the end cap. Use the screw-holes in the end caps for mounting to a

flat surface.

Figure 1. Features

Power LED

5V Strobe

LED

8-30V Strobe

LED

Input Terminal

Block

NPN/PNP

Select Switch

PresencePLUS

Light Terminal

Block

PAGE 1
Model PPLIM Light Interface Module DC-Powered Interface for PresencePLUS ® Lights Features • Low-cost strobe interface between user’s hardware and PresencePLUS lights • Separate Strobe Signal inputs: – 5V TTL signal – 8–30V dc signal (switch-selectable current sinking/NPN or current sourcing/PNP) • Two Light Strobe outputs: – 5V “Active Low” (non-inverting) – 5V “Active High” (inverting) • LED indicators for Power and Strobe Signal inputs • Easy-to-adjust 45° screw terminals for electrical wiring • Simpl
PAGE 2
Models PPLIM.. PresencePLUS Light Interface Module Specifications Input Supply Voltage 24V dc ±10% Strobe Output Non-Inverting “Active Low”: 5V @ 10 mA max. Inverting “Active High”: 5V @ 10 mA max. Adjustments NPN / PNP Select switch is dedicated to “8-30V Strobe” input only. When using “5V Strobe” input, put NPN / PNP Select switch in PNP position.