Specifications

10
To change the set temperature, depress and hold either arrow down for 3-4 seconds until
the display flashes “SU and the current set temperature. Depress and hold the appropriate
arrow to raise or lower the setting. The digits will change slowly initially but will increase
speed when held down longer for large changes. When the desired setting has been
reached, release the button. The display will continue to flash for a few seconds and then
display the current roller temperature.
Each time the machine is turned on it will heat up to the last set temperature.
5. Turn the MOTOR switch ON and perform a test lamination to ensure proper settings for
successful lamination. Watch film as it exits the rollers so it doesn’t wrap around the
rollers. It might be helpful to hold the film at first when starting a lamination run. If any
adjustments are necessary make them now and run another test. Repeat this step until
you obtain desired results.
6. Allow the MightyLam 2700HC to run a small amount of film before feeding the print into
the laminator to avoid a dwell line across your print. Feed the print slowly and evenly,
smoothing it as the rollers pull it through.
7. You may laminate subsequent prints now, leaving ample space between each print for
trimming.
8. Once your last print has completely exited the laminator, turn the MOTOR switch OFF.
9. When you have finished laminating, turn heat switch off.
10. With heavier gauges of film it is recommended that the fans be turned on. Be sure to turn
the fans off when the machine is sitting idle.
Coating Mount Board...
The MightyLam 2700HC is capable of applying an adhesive coating to mount board that has
not previous been coated.
1. Load a roll of adhesive, with the liner wound to the outside, onto the top mandrel in the
same manner as with laminating film.
2. Load a roll of paper on the bottom mandrel or use adhesive the same width as the mount
board to keep the adhesive from accumulating on the rollers.
3. Set the temperature to approximately 125°F. The MightyLam 2700HC will take
approximately 10-15 minutes to reach this temperature. The roller temperatures are
indicated on the LED displays.
4. Feed the uncoated mount board into the laminator behind a small leader board. The
leader board will prevent the compression of the leading edge of your mount board.
5. You may coat subsequent boards now, one directly behind the other, so that the board in
front becomes the leader board. We recommend that you coat a sufficient supply of mount
board in one session so you’ll have it ready for future use.