Safety Light Curtain Systems Owner manual

Receiver: A bi-color red/green Beam Status indicator for each beam shows
whether that beam is aligned and clear with a strong signal, clear but with a weak
signal, or is blocked and/or misaligned. A yellow Reset indicator shows when the
system is in Run mode or is waiting for a reset. A bi-color red/green Status
indicator shows when the OSSD outputs are ON (green) or OFF (red), or the
system is in lockout mode (flashing red). A 7-segment diagnostic display
indicates the receiver’s Trip (–) or Latch (L) configuration setting and displays a
specific error code when the receiver is in lockout. The 7-segment display also
momentarily indicates the scan code setting at power-up or when changed.
NOTE: If beam 1 is blocked, all other Beam Status indicators will be OFF, because
beam 1 provides the synchronization signal for all the beams.
page 42
Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: [phone]
System Operation
EZ-SCREEN Grid
Instruction Manual
Operating
Mode
Required
Event
Status
Indicator Diagnostic Display
Power-up Apply Power
Single-Flash
Red
Scan code flash 3x
(C1 or C2)
Alignment Mode –
Beam 1 Blocked
Passes Internal
Tests
Off Off
Alignment Mode –
Beam 1 Clear
Align Beam 1 Off Off
Run Mode –
Clear
Align All Beams On Green Dash
Reset
Indicator
Off
Off
Off
On
Beam Status
Indicators
All Single-Flash Red
Beam 1 Red
(1)
Others Off
Beam 1 Green
(2)
Others Red or Green
(2)
All On Green
(2)
On
Off
Off
Off
OSSD
Outputs
Figure 4-3a. Receiver status indicators and operation (Trip Output mode)
Figure 4-3b. Receiver status indicators and operation (Latch Output mode)
Operating
Mode
Required
Event
Status
Indicator Diagnostic Display
Power-up Apply Power
Single-Flash
Red
Scan code flash 3x
(C1 or C2)
Alignment Mode –
Beam 1 Blocked
Passes Internal
Tests
Off Off
Alignment Mode –
Beam 1 Clear
Align Beam 1 Off Off
Alignment Mode –
All Beams Clear
Align All Beams Off Off
Reset
Indicator
Off
Off
Off
Double-
Flash
Beam Status
Indicators
All Single-Flash Red
Red
(1)
Beam 1 Green
(2)
Others Red or Green
(2)
All On Green
(2)
Off
Off
Off
Off
OSSD
Outputs
Run Mode –
Clear
On Green All On Green
(2)
“L” On
Latched – Blocked
Block 1 or More
Beams
On Red Red or Green
(1), (2)
“L” Off
Latched – Clear Clear All Beams Flashing Red All On Green
(2)
“L” Off
Lockout Mode
Internal/External
Fault
Off Flashing Red Off
Displays Error
Code
Off
Lockout Mode
Internal/External
Fault
Flashing Red
Displays Error
Code
Off All Off Off
Notes:
(1) If beam 1 is blocked, all other beam indicators will be off.
(2) Flashing Green indicates a clear but weak signal.
* See Section 5.1 for a description of error codes
* See Section 5.1 for a description of error codes
*
*
Run Mode –
Blocked
Beam(s) Blocked Red DashOn Red or Green
(1), (2)
Off
Perform Reset