Owner's manual
EZA-TE Series Tubular Enclosures
Banner Engineering Corp., 9714 Tenth Ave. No., Minneapolis, MN USA 55441 • Phone: 763.544.3164 • www.bannerengineering.com • Email: sensors@bannerengineering.com
P/N 117107 Rev. D
Assembly Instructions
A. Place spacer disk on the QD end of the sensor housing, using
the two M5 x 8 mm screws. Torque: 30 in-lbs max.
B. Screw the top cap onto the non-QD end of the sensor
housing, using the two M5 x 14 mm screws and internal tooth
lockwashers (make sure o-ring is in place on top cap). Torque:
6 in-lbs max.
C. Being careful not to scratch the tubular housing, slide the cable
or terminated end of the cordset into the labeled end of the
clear tube and push it through, so it comes out the other end.
D. Connect the cordset to the sensor housing.
E. Slide the sensor housing into the clear tube until the top cap
mates with the tube flange. Make sure the o-ring seals against
the flat surface of the flange.
F. Screw the top cap to the tube flange using four #6-32 screws
and lockwashers. Torque: 15 in-lbs max.
G. Slide the bottom end cap over the unterminated end of the
cordset, making sure the o-ring is in place on the bottom cap.
H. Screw the bottom cap to the tube flange, using four #6-32
screws and lockwashers. Make sure the o-ring seals against
the flat surface of the flange. Torque: 15 in-lbs max. Tighten
the strain relief nut over the cordset cable.
I. Place the mounting bracket on the top cap and secure with
two #10-32 screws and external tooth lockwashers.
Torque: 50 in-lbs max.
J. Place the mounting bracket over the cordset cable and to the
bottom end cap; secure with two #10-32 screws and external
tooth lockwashers. Torque: 50 in-lbs max.
I
J
G
H
E
F
C
D
A
B
Figure 4. EZA-TE Series Tubular Enclosure assembly steps
Banner Engineering Corp. warrants its products to be free from defects in material
and workmanship for one year following the date of shipment. Banner Engineering
Corp. will repair or replace, free of charge, any product of its manufacture which,
at the time it is returned to the factory, is found to have been defective during the
warranty period. This warranty does not cover damage or liability for misuse,
abuse, or the improper application of the Banner product.
THIS LIMITED WARRANTY IS EXCLUSIVE AND IN LIEU OF ALL OTHER
WARRANTIES WHETHER EXPRESS OR IMPLIED (INCLUDING, WITHOUT
LIMITATION, ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR
A PARTICULAR PURPOSE), AND WHETHER ARISING UNDER COURSE OF
PERFORMANCE, COURSE OF DEALING OR TRADE USAGE.
This Warranty is exclusive and limited to repair or, at the discretion of Banner
Engineering Corp., replacement. IN NO EVENT SHALL BANNER ENGINEERING
CORP. BE LIABLE TO BUYER OR ANY OTHER PERSON OR ENTITY FOR ANY
EXTRA COSTS, EXPENSES, LOSSES, LOSS OF PROFITS, OR ANY INCIDENTAL,
CONSEQUENTIAL OR SPECIAL DAMAGES RESULTING FROM ANY PRODUCT
DEFECT OR FROM THE USE OR INABILITY TO USE THE PRODUCT, WHETHER
ARISING IN CONTRACT OR WARRANTY, STATUTE, TORT, STRICT LIABILITY,
NEGLIGENCE, OR OTHERWISE.
Banner Engineering Corp. reserves the right to change, modify or improve the design
of the product without assuming any obligations or liabilities relating to any product
previously manufactured by Banner Engineering Corp.