User guide

Banner Engineering Corp., 9714 Tenth Ave. No., Minneapolis, MN USA 55441 • Phone: [phone] • www.bannerengineering.com • Email: [e-mail]
MSHDA-TE Series Tubular Enclosures
P/N 117106 rev. B
WARRANTY: Banner Engineering Corp. warrants its products
to be free from defects for one year. Banner Engineering
Corp. will repair or replace, free of charge, any product of its
manufacture found to be defective at the time it is returned to
the factory during the warranty period. This warranty does not
cover damage or liability for the improper application of Banner
products. This warranty is in lieu of any other warranty either
expressed or implied.
Assembly Instructions
A. Place spacer disk on the QD end of the sensor housing,
using the two M5 x 8 mm screws. Torque: 30 in-lbs max.
B. Screw the top cap onto the non-QD end of the sensor
housing, using the two M5 x 10 mm screws and internal
tooth lockwashers (make sure o-ring is in place on top cap).
Torque: 6 in-lbs max.
C. Being careful not to scratch the tubular housing, slide the
cable or terminated end of the cordset into the labeled end of
the clear tube and push it through, so it comes out the other
end.
D. Connect the cordset to the sensor housing.
E. Slide the sensor housing into the clear tube until the top
cap mates with the tube flange. Make sure the o-ring seals
against the flat surface of the flange.
F. Screw the top cap to the tube flange using four 6-32 screws
and lockwashers. Torque: 15 in-lbs max.
G. Slide the bottom end cap over the unterminated end of the
cordset, making sure the o-ring is in place on the bottom
cap.
H. Screw the bottom cap to the tube flange, using four 6-32
screws and lockwashers. Make sure the o-ring seals against
the flat surface of the flange. Torque: 15 in-lbs max. Tighten
the strain relief nut over the cordset cable.
I. Place the mounting bracket on the top cap and secure with
two 10-32 screws and external tooth lockwashers.
Torque: 50 in-lbs max.
J. Place the mounting bracket over the cordset cable and to the
bottom end cap; secure with two 10-32 screws and external
tooth lockwashers. Torque: 50 in-lbs max.
A
B
C
D
E
F
Figure 4. MSHDA-TE Series Tubular Enclosure assembly steps
G
H
I
J