Owner's manual

Speifications
8
Banner Engineering Corp. • Minneapolis, U.S.A.
Website:http://www.baneng.com • Tel:888.373.6767
2. Specifications
2.1 Emitter and Receiver Specifications
Emitter/Receiver Range
Specifiedatthepointwhere
3xexcessgainremains.
3/8" beam spacing
Minimum Object Sensitivity
3/8" beam spacing
Power Requirements
†
Maximumcurrentisfora6'
sensor.
3/8" beam spacing
Status Indicators
Emitter: RedLEDlightstoindicateproperemitteroperation
Receiver: Greenindicatessensorsaligned(>3xexcessgain)
 Yellowindicatesmarginalalignmentofoneormorebeams
 Redindicatessensorsmisalignedoroneormorebeam(s)blocked
Sensor Scan Time
55microsecondsperbeam,pluspostprocesstimeperscan.Postprocesstimewillvary,basedonthe
numberofchannelsinterrogatedduringeachscan.Seepage20foradescriptionofscantimeforeach
scanningmethodandtheformulaforcalculatingpostprocesstime.
Connections
Sensorsconnecttocontrollerusing5-conductorquick-disconnectcables(oneeachforemitterand
receiver),orderedseparately;seepage5foravailablelengths.UseonlyBannercables,whichincorporatea
“twistedpair”fornoiseimmunity.Cablesmeasure8.1mm(0.32")dia.andareshieldedandPVC-jacketed.
Conductorsare20gauge(0.9mm).Emitterandreceivercablesmaynotexceed75m(250')long,each.
Construction
Aluminum,withblackanodizedfinish;acryliclenscover
3/4" beam spacing
3/4" beam spacing
Straight, Edge Modes:19.1mm(0.75")
Skip Mode:Multiplytheabovebythenumberof
skippedbeams,plus1
Interlaced Mode:12.7mm(0.5")*
Straight, Edge Modes:38.1mm(1.5")
Skip Mode:Multiplytheabovebythenumberof
skippedbeams,plus1
Interlaced Mode:25.4mm(1.0")*
Sensors < 4':0.6to6.1m(2'to20')
Sensors > 4':0.6to4.6m(2'to15')
Sensors < 4':0.9to17m(3'to55')
Sensors > 4':0.9to14m(3'to45')
3/4" beam spacing
12Vdc±2%,suppliedbycontroller
Emitter:0.10A@12Vdc
Receiver beam spacing:0.50A@12Vdc
†
12Vdc±2%,suppliedbycontroller
Emitter:0.10A@12Vdc
Receiver beam spacing:0.75A@12Vdc
†
Environmental Rating
NEMA4,13(IP65)
Operating Conditions
Temperature:-20°to+70°C(-4°to+158°F)
Maximum relative humidity:95%at50°C(non-condensing)
*Assumessensingisinthemiddle1/3ofsensingrange.